At least so far. The first go round had the nozzle crash into the tree support, resulting in a layer shift. The good news is that the print stayed very firmly stuck to the bed.

I’ve reset, lowered my extrusion multiplier a smidge, switched to a more traditional support pattern, and am going for it again. Wish me luck!

  • Dkarma@lemmy.worldEnglish
    12·
    3 months ago

    What the holy hell is this nonsense?

    You guys will do anything to keep from buying a good printer won’t you?

    I’ve done 21 hours prints in my damp cold basement without issue.

    You guys make me feel so competent haha.

    • j4n3z@lemm.eeEnglish
      2·
      3 months ago

      Imagine feeling so confident to indirectly call Voron a bad printer and tell people how to spend money.

      Go get yoursel something to work on instead of mocking other for their temporary solutions.

    • IMALlama@lemmy.worldOPEnglish
      1·
      3 months ago

      ASA and ABS are warp prone and this is an 11" / ~275mm wide print that’s equally tall 🤷

      The build volume of my printer means lots of surface area for the acrylic enclosure, which in turn makes it hard for me to exceed a 50°C chamber temp, despite 4x bed fans.

      The next print, with normal supports, pulled the bed off the magnetic build plate. Insulation eliminated warping and let me pull off the print.

      I do agree that a “nicer” enclosure is the preferred method. I have zero issues with PETG at this size. I’ve never tried PLA on this printer, but it should be fine too.