mibzman@lemmy.ml to 3D Printing@lemmy.mlEnglish · 2 years agoWhat are you printing this week?message-squaremessage-square38fedilinkarrow-up117arrow-down10
arrow-up117arrow-down1message-squareWhat are you printing this week?mibzman@lemmy.ml to 3D Printing@lemmy.mlEnglish · 2 years agomessage-square38fedilink
minus-squareContend6248@feddit.delinkfedilinkarrow-up2·2 years agoIs that top layer ironed? It looks very clean
minus-squareWilshire@beehaw.orglinkfedilinkarrow-up1·2 years agoI wish, but I think I flipped it over and that’s the side that was on the bed. My TPU top layers always look like crap.
Is that top layer ironed? It looks very clean
I wish, but I think I flipped it over and that’s the side that was on the bed. My TPU top layers always look like crap.