Have you played around with the Support Z distance, Support Top Distance, Support Interface? By default (at least with Cura), supports sit a layer or two below where they’re supposed to contact the print so you get shitty overhangs 100% of the time. The tradeoff is that you can easily remove them from the print. You might also try out Tree supports if you haven’t already. They’re a breeze to remove even with zero offset.
Have you played around with the Support Z distance, Support Top Distance, Support Interface? By default (at least with Cura), supports sit a layer or two below where they’re supposed to contact the print so you get shitty overhangs 100% of the time. The tradeoff is that you can easily remove them from the print. You might also try out Tree supports if you haven’t already. They’re a breeze to remove even with zero offset.