Any books you would recommend?

This sounds fantastic!

I really wish I could run Linux but almost all of the software I use for work is only on Windows.

But I will say I am decent in following instructions and using the cli. My mum’s system runs linux and that has been a learning experience.

My only real exposure to coding is C in Turbo C++ it was not a nice surprise when I later looked at other IDEs and was not sure where to begin. Maybe I’ll just get started with Turbo again lol.

Some linux iso management, some CAD software steps that I want to automate. My very general target is to get comfortable with trying to look up documentation, scripting and make my own code bashes for local use cases.

Looks interesting, I’ll check it out!