• 7 Posts
  • 42 Comments
Joined 2 years ago
cake
Cake day: July 6th, 2023

help-circle


  • In defense of this, I work on a service that uses square and allows tips. One of the issues with square tips is you can only ask for percentages, not dollar amounts. Since the service I work on usually costs $1-2, we have to put in high percentages for tips in order for it to be meaningful. I believe ours is set to 25, 50, 75 and 100%. Which is usually equivalent to <$2. They could have had a similar situation here except whatever service they offer ended up being far higher than normal.









  • I had an ender 3 as well. Every time I used it I had to calibrate and level it, and watch the the print for the first few layers to make sure it was going to work. I’d estimate it had failed prints around 50% of the time. Eventually it died and I got a anycubic kobra printer. It is so much better it’s unbelievable. I leveled it once when I first assembled it. Since then I haven’t calibrated it or leveled the bed once. I’ve done over 100 prints on it with a 0% failure rate. It is truly a printer where I can tell it to print something and come back 10 hours later and have a perfect print.