You’re correct, phase-to-phase is 173.2% of the phase-to-neutral voltage in 3-phase “Wye” service.
But that’s not what consumers (typically) use in North America. We don’t bring three phase to the home.
Our single-phase final distribution transformers have a center tap on the secondary coil, bonded to neutral. So, one side of the coil provides a 120v leg with respect to that neutral, and the other side provides an opposing leg, 180° from the first, and 120v with respect to that same neutral. Most of our appliances use leg-to-neutral, 120v. But leg-to-leg is 240v.
(Commercial and industrial facilities can get a wide variety of voltages in single or three phase, and we do have some actual, 2-phase generators and customers: the phases are 90° apart rather than 120° or 180°)
The technology connections video talking about 240v power mentioned some apartment buildings having 208v because they’re bringing in two phases instead of center tapping or whatever. So their comment could be right in the correct locations i think.
And lots of things meant to run on 240 are dual labeled 208/240. If it’s a motor it will end up running a little hotter, if it’s a heater it will end up a little colder.
Splice on a second plug, so you can use two outlets at the same time.
(/s, mostly… this can actually work, if you can find two outlets on opposite phases.)
There’s an actual commercial product that does this. It even meets UL and CSA standards.
But it wouldn’t be 200%, it would be something like 170% power assuming 3 phases, right. Too lazy to do the math.
You’re correct, phase-to-phase is 173.2% of the phase-to-neutral voltage in 3-phase “Wye” service.
But that’s not what consumers (typically) use in North America. We don’t bring three phase to the home.
Our single-phase final distribution transformers have a center tap on the secondary coil, bonded to neutral. So, one side of the coil provides a 120v leg with respect to that neutral, and the other side provides an opposing leg, 180° from the first, and 120v with respect to that same neutral. Most of our appliances use leg-to-neutral, 120v. But leg-to-leg is 240v.
(Commercial and industrial facilities can get a wide variety of voltages in single or three phase, and we do have some actual, 2-phase generators and customers: the phases are 90° apart rather than 120° or 180°)
The technology connections video talking about 240v power mentioned some apartment buildings having 208v because they’re bringing in two phases instead of center tapping or whatever. So their comment could be right in the correct locations i think.
I’m clearly no sparky.
Correct. It’s not typical, but it does exist. 208v is usually close enough for 240v appliances.
And lots of things meant to run on 240 are dual labeled 208/240. If it’s a motor it will end up running a little hotter, if it’s a heater it will end up a little colder.
They are referring to recombining the two halves of split-phase like what is done with an outlet for an electric dryer or oven, but outside the walls.
https://theengineeringmindset.com/120-240v-split-phase-us-can/